Procom EDP200T2-C, Manual, Page: 22 / 27

OBSERVED
PROBLEM
REMEDY POSSIBLE CAUSE
White powder
residue forming
within burner box
or on adjacent
walls or furniture 1. When heated, the vapors from furniture
polish, wax, carpet cleaners, etc., turn
into white powder residue.
1. Turn heater off when using furniture
polish, wax, and carpet cleaner or similar
products.
When ignitor button
is pressed in, 1. Ignitor is positioned wrong.
2. Ignitor electrode is broken.
3. Ignitor electrode is not connected to
ignitor cable.
4. Ignitor cable is pinched or wet.
5. Broken ignitor cable.
6. Bad piezo ignitor.
1. Replace ignitor.
2. Replace ignitor.
3. Reconnect ignitor cable.
4. Free ignitor cable if pinched by any
metal or tubing. Keep ignitor cable dry.
5. Replace ignitor cable.
6. Replace piezo ignitor.
When ignitor button
is pressed in, there
is no spark at
ODS/pilot. 1. Gas supply is turned off or equipment
shutoff valve is closed.
2. Control knob not fully pressed in while
pressing ignitor button.
3. Air in gas lines when installed.
4. ODS/pilot is clogged.
5. Gas regulator setting is not correct.
6. Bad piezo ignitor.
7. Depleted gas supply.
1. Turn on gas supply of open
equipment shutoff valve.
2. Fully press in control knob while
pressing ignitor button.
3. Continue holding down control knob.
Repeat igniting operation until air is
moved.
4. Clean ODS/pilot (see Care and
Maintenance Page 19) or replace
ODS/pilot assembly.
5. Replace gas regulator.
6. Turn control knob to Pilot position.
7. Contact your local gas company.
ODS/pilot lights but
flame goes out
when control knob
is released
1. Control knob is not fully pressed in.
2. Control knob is not pressed in long
enough.
3. Equipment shutoff valve is not fully open.
4. Thermocouple connection is loose at the
control valve.
5. Thermocouple damaged.
6. Control valve damaged.
1. Press in control knob fully.
2. After ODS/pilot lights, keep control knob
pressed in 30 seconds.
3. Fully open equipment shutoff valve.
4. Hand tighten until snug, and then tighten
1/4 turn more.
5. Replace thermocouple.
6. Contact Dealer or Customer Service.
22