Operation
10 / 14
58500009/58500010/58500011
V3
GB
4
Operation
4.1
Allgemein
•
Do not tear on fixed loads.
•
In case of power loss, put the load down immediately, if possible. Remove yourself from the danger
zone right away.
•
Suck in and lift only suitable loads (Check inherent stability and surface density).
•
Only put down the loads on clear and even surfaces. Otherwise they could slip off when released.
•
Release the load only after it has been put down completely and safe.
•
Keep hands away from the load when releasing.
•
Load the suction surface always uniformly.
4.2
General
•
Do not tear off stuck loads.
•
In the event of a power failure, immediately disconnect the load if possible. Remove yourself
immediately from the danger area.
•
Only suck in and lift suitable loads (check inherent stability and surface density).
•
Only place the load on a free, level surface. Otherwise they can slip when released.
•
Do not release the load until it is completely and securely supported or standing.
•
Keep hands away from the load when releasing.
•
Always load the suction surfaces evenly.
4.2.1
Lifting loads
•
Position the device directly above the load.
•
Place the device on the load. Ensure even load distribution.
•
The load is now sucked in.
•
When lifting, make sure that only one piece of the material to be lifted is lifted at a time. Carefully
remove any other adhering parts with a screwdriver before you lift the part further. Do not loosen
with your hands,
danger of crushing!
4.2.2
Releasing loads
•
Lower the load and lay it down safely on a free, flat surface so that the load cannot slip or tip over.
•
Press the red release button to release the sucked load.
•
Load is now released.
