8
Visit www.probrite.com/install for installation video tutorials and product support
A
B
INSTALLATION (CONTINUED)
7
MOUNT THE LIGHT
FIXTURE
☐
Once the fixture is wired, place the light
fixture (A) onto the mounting plate (D)
so the top sloped groove on the plate rests
on the top sloped groove on the back of the
fixture.
☐
Verify the fixture is flush with the
mounting surface and photocell (B) is
pointed downward for wall mount or
away from building on eave mount.
☐
Tighten the mounting plate set screw
(C) on the bottom of the fixture (A) until
the screw firmly pushes against the
mounting plate (D).
8
CAULK AROUND THE
LIGHT FIXTURE
☐
9
☐
After fixture is securely mounted, manually aim
each lamp head on the fixture (A) to point toward
the direction desired.
☐
If one or both heads on the fixture (A) appear
loose, use a philips head screwdriver to
tighten the screws located on the arms of
the light heads.
☐
To test light fixture illumination, cover
photocell (B) and turn power back ON from the
breaker and switch. Adjust lamp heads as
needed to achieve desired lighting pattern.
A
B
WARNING: Risk of fire. Keep the lamp heads
at least 3 in. (76mm) from combustible
materials.
CAUTION: Keep lamp heads 30° below
horizontal to prevent water damage and
electrical shock.
C
DD
(fig 10).
(fig 11).
(fig 12).
NOTICE: Failure to properly caulk around the
back face of the light fixture and mounting surface
could lead to water damage and is not covered under
warranty.
NOTE: When attaching the light fixture (A) to a
surface mount junction box, caulk between the
mounting plate and junction box.
Caulk around the fixture and surface
with silicone sealant (not included) as
shown in (fig 11).
AIM THE LAMP
HEADS AND TEST
D
