Turn the temperature control dial until you hear a click – this will turn the unit on.
Continue turning the dial to your desired temperature. The temperature control
dial acts as a thermostat. Once the room has reached the desired temperature
the unit will switch off.
3.
Overheat Protection:
When the temperature of the heater is too high, the
thermostat will automatically switch off the power and the heater will stop
working. This may occur during improper use or certain environmental condi-
tions. After the heater has cooled, the heater can be used normally.
Tip-over Protection:
When the heater is knocked over or tipped onto its side, the
safety switch will automatically cut off power. Power will return to normal when
the unit has been placed upright onto an even surface.
-
-
Turn the power/oscillation control dial to the OFF position.
Turn the temperature control dial anticlockwise to the lowest setting.
Remove the power plug, store the heater after the unit has cooled down.
1.
2.
3.
Switching Off
Note
Switching On and Setting Temperature
Insert the plug into the power socket.
Turn the power/oscillation control dial to the desired level:
1.
2.
Low heat (1000W)
Low heat with oscillation (1000W)
High heat (2000W)
High heat with oscillation (2000W)
WARNING:
Always turn the heater OFF, unplug the power cord from the electrical
outlet and allow the appliance to completely cool down before handling or cleaning it.
CAUTION:
Do not allow water or other liquids to run into the interior of the heater, as
this could create a fire and/or electrical hazard.
CAUTION:
Do not use any abrasive cleaners or solvents, as heater damage will occur.
CLEANING & STORAGE
5 | English
PB-H07_03.2021_Instruction Manual.pdf 6 19/03/2021 10:56
