Shockwave 26
Battery Chemistry Switch
This switch allows the ESC to detect voltage. When the
switch is in the OFF position, low voltage cutoff (LVC)
is disabled. You will know you have reached LVC when
the motor power decreases while the boat is in operation.
li-po:
move battery chemistry
switch to ON position
Ni-MH:
move battery chemistry
switch to OFF position.
Tip:
The ESC programming card
(DYNM3821, sold separately) allows the consumer to
adjust low voltage cutoff and other ESC programming.
Introduction
Once you hit the water, it’s full speed ahead. The ready-to-run Pro Boat
®
ShockWave
®
26 Deep-V boat is agile
on the lake and easy on the eyes. It’s the one boat that’s both no-nonsense and incredibly fun at the same time.
Whether you’re new to RC boating or an experienced pro, the Shockwave 26 will keep you coming back for more.
Refer to this manual for instructions about assembly required to prepare your boat for operation.
Register your boat online at www.proboatmodels.com.
Battery Safety precautions
• When using a Li-Po battery, always ensure the
Battery Chemistry Switch is in the ON position.
• Never discharge a Li-Po battery below 3V per cell.
• Always disconnect a battery from the ESC
when not in use.
• Avoid continually operating to LVC, as
this could result in damage to the battery.
At the factory, the ESC is programmed at High Cutoff.
High Cutoff:
The Ni-MH cutoff voltage is .9 volts per
cell and the Li-Po cutoff is 3.3 volts per cell. High Cutoff
allows ample power in reserve after cutoff for returning
the boat to shore.
low Cutoff:
The Ni-MH cutoff voltage is .7 volts per
cell and the Li-Po cutoff is 3.0 volts per cell. Low Cutoff
allows longer run times, but leaves less power in reserve
after cutoff for returning the boat to shore.
3
EN
Specifications
length
26 in (660mm)
Beam
4.375 in (111mm)
Transmitter
Spektrum 2.4GHz
Pistol Grip Transmitter
(DX2E)
Receiver
Spektrum
™
MR200
Hull Material
ABS Plastic
Motor
1500Kv
ESC
45 Amp brushless
4 AA batteries (sold separately) are
required to operate the transmitter.
Recommended Tools and Materials
• Needle nose pliers
• Paper towel
• Rubbing alcohol
• Open-end wrench: 10mm (2)
• Nut driver: 7mm
• Phillips screwdriver: #1
• Hex wrench: 2.5mm, 3mm
• Clear tape (PRB0102)
• Pro Boat
®
Marine Grease and Gun (PRB0100)
• Li-Po battery (DYNP4000EC)
or Ni-MH Battery (DYN1080EC)
• Li-Po battery charger (DYN4066)
or Prophet
™
Sport AC/DC Peak
Ni-MH Charger (DYN4056)
product Inspection
Carefully remove the boat and radio transmitter from
the box. Inspect the boat for damage. If you find
damage is present, please contact the hobby
shop where you purchased your boat.
Contents
