6
Required Equipment and Accessories
Transmitter
AA battery (4)
Motor battery (2) (charged)
Hook and loop tape
1. Apply the hook and loop tape to the
bottom of both batteries. Also apply the
mating piece of tape in the hull where the
batteries will be located.
2. Place the motor batteries in the hull.
There will be one battery on the left of the
hull, and one on the right side of the hull.
Note: Center the trims for both the
steering and throttle on your transmitter
before turning the transmitter on.
3. Move the switch on the transmitter to
the ON position and confirm that the red
and green LED illuminate. Turn off the
transmitter.
About your Speed Controller
Be sure to use a Programming Module
(PRB3311) to adjust the cutoff voltage when
using Ni-MH batteries to protect against over-
discharging the batteries.
Note: The ESC is factory-set for use with
Li-Po batteries.
The programming module offers other
beneficial adjustments like exponential
throttle curves and timing adjustments. Visit
ProBoatModels.com and search "Programming
Module" for further details.
4. Confirm that the ESC on/off switch
is in the "OFF" position and connect the
batteries to the battery plugs from the
speed control.
Battery Installation
