ProBoat PRB3050S, Owner'S Manual

Page: 7 / 16

7
Before and at the end of each run, make sure that
all screws are tight and that the propeller is free
from any entanglement.
If you have any questions concerning the setup
or running of the Volere, please contact the
appropriate Horizon Product Support department.
Lubricating the driveshaft is vital to the life of the
drivetrain. The lubricant also acts as a water seal,
keeping water from entering the hull through the
stuf fi ng box.

1. Remove the front seat from the cockpit
by tipping it rearward and lifting it from
the cockpit. The seat is held in position by
magnets.

2. An oiling port has been installed on the
stuf fi ng box for lubricating the driveshaft. Fill
the oil port with a light oil (available at any
hardware store) prior to operation.
After each day of operation, remove the driveshaft
to clean and remove debris.

1. Remove the 1.5mm setscrew on the motor
coupler.

2. Use a .050 hex wrench or a small piece of
music wire to remove the nut securing the
propeller. Remove the propeller and hardware
from the driveshaft.

3. Slide the driveshaft out of the boat from the
rear. Move the rudder slightly to clear the
driveshaft.
Maintenance and Lubricating the Driveshaft