10
Cables & Control Box
Setup
Install the 12 volt DC power (4-pin XLR) in
rear of Joystick Box.
NOTE:
Any 12 volt battery may operate the PROAIM Sr. PAN TILT HEAD as long as the connector mates
and is #1 pin Negative and #4 pin Positive.
CAUTION:
DO NOT USE AN UNREGULATED POWER SUPPLY! IF USING A REGULATED POWER SUPPLY IT
MUST PRODUCE LESS THAN 12 VOLTS. MORE THAN 24 VOLTS MAY CAUSE PERMA-NENT DAMAGE.
JOYSTICK
The joystick may be operated hand held, from a flat surface like a table top or attached to the boom arm
of the jib.
Attach the 4-pin power cord to the rear of
Joystick Box.
HEAD CABLE
PROAIM SR. PAN TILT HEAD Digital only
PROAIM Sr. PAN-TILT HEAD Digital only
Attach 4-pin male connectors of cable to the
four pin female connectors of head for
panning & tilting.
If the Joystick Control is opposite, undo the
connectors at the motors rotate 180 degrees
and re-install.
Attach & secure your camera on camera
platform of Head with help of provided bolt.
