Usage instructions Adapter & Adaptation
30
•
To change the
angle adjustment of the clamp cover
, attach the clamps on the steering head
connection so they vertically mirror the adapter. The screw heads of the M6 tensioning screws are
then visible on the other side (wheelchair or product side) as before, coloured yellow in the figure.
With this modification, the frame clamps must then be reattached to the wheelchair side. To do
this, the clamp cover must be released from the steering head connection clamp and repositioned.
To this end, see chapter 6.5.
•
To change the
position of the holder drill hole of the clamp cover
, turn the steering head con-
nection clamps by 180°. When this position is changed, the angle adjustment of the clamp cover
also changes. To return the angle adjustment of the clamp cover to the initial position once more,
proceed as described above. Shown in purple in the figure.
If the steering head connection clamps are now put in the new position on the adapter, the M4
threaded pins must be loosened again by several turns and the M6 tensioning screws must be tight-
ened with a tightening torque of 7 Nm and secured with screw locking fluid. The threaded pins are
then screwed in again gently making contact with the clamp. See chapter 6.1.
