Usage instructions Adapter & Adaptation
22
7.3
Detaching the adapter from the
product
For the NJ1 e-assistant & HUSK-E:
Please ensure that the drive system is
switched off.
To detach the product, the stands are first
moved to the active position, the handbrake on
the product is activated and – if possible – the
product is parked against a wall (refer to the
"Parking stands" and "Parking brake" chapters
in your
product usage instructions).
The securing bolt is now pulled out completely
again to the outer stop, the pre-selection lever
grid mechanism is switched to "unlock" (upright
position), and the eccentric clamp lever is
turned to "loose".
Figure 73: Preparation for detachment
Now use the grip rings to move your wheel-
chair towards the adapted product. The prod-
uct and wheelchair lift slightly until the grid
mechanism clicks out with an audible noise.
Then your wheelchair is lowered onto the
caster wheels again by taking the pressure off
the grip rings and the lock is detached.
Figure 74: Move towards the product until the
unlocking noise is heard
Note for decoupling with a central adapter:
If it is not possible to lock the product (e.g. no
fixed barrier available) it is also possible to
release the grid mechanism by pushing the
product forwards and upwards on the manoeu-
vring bar (option), bottom bracket or chain
blade protection until the unlocking noise is
heard. By slowly lowering the product (move-
ment direction of the chain protection or bottom
bracket towards the body) the front caster
wheels of the wheelchair are lowered to the
ground.
The product can now be lowered on to the
ground in front of the wheelchair and you can
remove the wheelchair from the product.
Additional information for the front adapter:
After decoupling from the wheelchair, the front
adapter can remain on the product. For this
purpose, the carabiner hooks of the coupling
fittings remain coupled to the lifting eye of the
bottom bracket support. After your wheelchair
is lowered down to the caster wheels again
after relieving the handrims and the locking
has been released, the insertion shaft of the
adapter can be hung into the insertion bolt of
the docking plate. Then decouple the adapter
from the wheelchair and leave the adapter in
the suspended position on the product with the
quick-snap mechanism opened. This facili-
tates the coupling of the adapter on the wheel-
chair again, as the adapter is already at the
right height.
Securing bolt removed
Direction of
travel
Eccentric
clamp lever
to "loose"
Pre-selection lever grid mechanism
is switched upwards to "unlock"
