KEYPAD OPERATIONS
Entry/Exit Delay
This is a programmable delay time that must be used to operate the interior keypad. In arming the alarm, the alarm will not be
activated or the siren will not sound until after the preset delay from 0 to 35 seconds in 5-second increments has expired. The delay
is programmed when the alarm is in the STANDBY MODE (the on-board led is not blinking).
To check the delay time, press and release the pushbutton S1.
The siren will beep to indicate the programming mode. The status led D7 will flash to indicate the current delay time (see chart). If
the button is not pressed again quickly, another beep will indicate the return to STANDBY MODE, keeping the selected delay value.
To change the delay time, press S1 to enter the programming mode. Once the led flashes indicate the current setting, press S1 again
to go to the next delay setting. The led will flash to indicate the delay time (see chart). Discontinue pressing S1 once the desired
delay time has been reached. The alarm will return to the STANDBY MODE.
DELAY TIME (sec) LED FLASHES
0
8 fast flashes
5
1 flash
10
2 flashes
15
3 flashes
20
4 flashes
25
5 flashes
30
6 flashes
35
7 flashes
STEP-BY-STEP:
1. Momentarily press the pushbutton switch S1
2. After a beep Red led D7 flashes to indicate the current delay setting (see chart)
3. To change the delay setting, momentarily press switch S1 again
4. If the led flashes indicate an undesired delay setting, continue step 3
5. Once the desired setting is reached, do nothing – a second beep indicates the end of the delay programming mode.
