Congratulations on your purchase of a state-of-the-art trailer security system.
This system has been designed to provide years of trouble-free operation.
What it does
The Pro-Tec System Two is designed to monitor and protect your trailer and its contents while at a race, job site, rest stop, hotel,
restaurant, etc. This is accomplished by door switches and an accelerometer. Any acceleration of the trailer or opening of a door will
trigger the alarm. This will cause the electrical brakes of the trailer to be applied, running lights will then flash, and the siren will
sound. If you have the optional pager system, or cellular dialer, you will be notified of a potential problem.
This device complies with part 15 of FCC rules. Operation is subject to the following conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
This Owner’s Guide should help you get the most out of your system. Please take the time to read it thoroughly, prior to using the
system.
What is included:
1 Control module
2 Transmitters
1 Siren
1 Brake safety toggle switch
3 Pin type door switches
3 Door switch brackets
Mounting screws
5 Crimp connectors
1 Double membrane entry seal
Insurance rebate card
Warranty card
2 Vinyl Decals
PTS-2P Package includes:
All the above plus:
Pager and base unit
PTS-2C Package includes:
All the above plus:
Cellular Dialer
Optional Equipment:
Momentary Key Switch N/O
LED Light
Interior Key Pad
Cellular Dialer
Paging system
Note: Pager requires AM/FM antenna (not included).
Control box
■
Recommended Mounting - Position High on the front wall. The higher the control box is mounted the better the reception would
be.
■
Wire Routing - Use one of the punch outs on the
“S1”
side of the box. Snap in the double membrane entry seal to the hole you
punched out.
■
Cut the dimple off the outer side of the entry seal.
■
Pass the wires thru entry seal and route to designated terminal block position.
