3
1
2
A1x6
B2x2
B3
A4x2
A3x2
A7
A2x4
A3x4
A4x4
A7
B1
4
5
Place the glass base on a table, glossy side facing
downward.
Attach the self-adhesive feet, one near each corner,
one each centered along of the front and rear edge,
as shown.
Holding the base vertical, and laying the rear supports
on the table, attach the rear supports to the base as
shown, using (A2) plastic washers, (A3) metal washers
and (A4) hex head screws. Make sure the (A2)
washers are between the (A3) washers and the base.
Be certain that the mounting holes on the rear supports (B2)
are located at the top of the rail, as shown in illustration
#2 and #3.
Tighten the hex head screws with the supplied (A7) Allen
wrench. These should be quite snug but do not
over-tighten, as damage to the base may occur.
As mentioned on the previous page, it may be easier to
lay the glass base flat, with the holes over the edge of
a desk, and the (B2) rear supports positioned vertically.
Once attached, position the rear supports upright, and
attach the top mounting plate (B3) across the two (B2)
rear supports
Using the (A4) screws and (A3) metal washers, attach
the plate to the top of the (B2) supports as shown in
illustration #3. It may be necessary to loosen the lower
screws and tighten all four at the same time in order to
ensure the rear supports are straight.
