PRO-PULSE 5969003, Operator'S Manual

Page: 34 / 57

JF72553B
34
ELECTRICAL REQUIREMENTS AND SAFETY
Make sure your extension cord is properly wired and in good condition. Always replace a damaged
extension cord or have it repaired by a
TXDOL¿HG
technician before using it. Protect your extension
cords from sharp objects, excessive heat and damp or wet areas.
To avoid electrical hazards, ¿UH hazards or damage to the tool, use proper circuit protection.
This tool is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt /
15 Ampere time delay fuse or circuit breaker. To avoid shock or
¿UH replace power cord immediately
if it is worn, cut or damaged in any way. Before connecting your tool to the power line, make sure the
switch is in the off position and the electric current is rated the same as the current stamped on the
motor nameplate. Running at a lower voltage will damage the motor. This tool is intended for use on
a circuit that has a receptacle.
In all cases, make certain the receptacle is properly grounded. If you are not sure, have a
TXDOL¿HGHOHFWULFLDQFKHFNWKHUHFHSWDFOH
This tool is for indoor use only. Do not expose to rain or use in damp locations.
!
WARNING
!
WARNING
This tool must be grounded while in use to protect the operator from electric shock.
MINIMUM GAUGE FOR EXTENSION CORDS (AWG)
(When using 120 volts only)
Ampere Rating Total of cord length
More Than Not More Than 25ft. 50ft. 100ft. 150ft.
0 6 18 16 16 14
6 10 18 16 16 12
10 12 16 16 14 12
12 16 14 12 Not recommended
ENGLISH