DON’TS
Do not cut into the Gas Pricer PCB at any point.
Do not drill into the Gas Pricer PCB.
Do not cut/modify any part of the Gas Pricer extrusion.
Do not cut/modify any part of the Gas Pricer mounting brackets.
Do not use any other power supply type to power the Gas Pricer units other than the ones supplied.
Do not use the provided power supplies to power any other lighting in the sign cabinet.
Do not install the provided power supplies lower than 2” from the bottom of the cabinet.
Do not touch the Gas Pricer LED bulbs during installation.
Do not install the provided power supplies more than 15 feet away from the Gas Pricer units.
DO’S
Do mount the provided power supplies in the lower half of the cabinet at least 2” from bottom.
Do handle the Gas Pricer units by the corners.
Do install forced or passive venting to keep the cabinet temperature below 160˚F.
Do make sure there is no exterior water dripping into the cabinet
Do make sure that the brightness level setting of the Gas Pricer units are set to 1.
Page 18
