14
Verify that the fan is running and that there is steady airflow out of
the air conditioning vent.
Turn the mode control knob to run. This will start the compressor
and seawater pump.
Check for a steady solid stream of seawater from the overboard
discharge (thru hull).
To set the thermostat, allow sufficient time for the unit to cool the
area to the desired temperature. When the area is sufficiently
cooled, turn the thermostat knob slowly toward the center position
until it clicks once. The thermostat is now set to maintain a
constant temperature.
Air conditioning vent
(air supply grille)
Caution: Do not turn the unit off and immediately turn it back on. Wait at least 2 minutes for the
system refrigerant pressures to balance.
Please refer to the owner’s manual provided by the manufacturer of the air conditioning system and associated
components listed in this section for operational procedures and for information related to the care and
maintenance of their products. When in doubt, always defer to the component manufacturer’s instructions and/or
recommendations.
Note: The manufacturer of the air conditioner provides the limited warranty for the air conditioner
and most associated parts. Please refer to their owner’s manual and follow their
recommendations for scheduled maintenance and service. All service and/or warranty repairs
must be performed by a repair facility that is authorized to work on their equipment.
Switch and Breaker Panel
The switch and breaker panel is located on the console and is equipped with 10 switches. The numbers shown
above each switch in the photo above correspond with the following descriptions provided for each switch:
Circuit Breakers – On the switch panel below the individual switches
1 2 3 4 5 6 7 8 9 10
1 Horn - The horn is used to signal, warn, or alert other boats, swimmers or people on shore. Depress the
horn switch to the up or forward position to activate the horn. Release the horn switch to deactivate the
horn. Using different sequences of horn blasts indicates different and sometimes dangerous situations to
you or someone around you. Avoid any horn use without an appropriate purpose. See the Safety Section
in this manual and/or take a safe boating course for more information on the proper use of the horn.
2 Navigation and Anchor Lights - Locate the Nav. light switch on the instrument panel. This is a 3-way switch
(forward, middle, back/aft) that functions as follows when you press the switch:
Forward position - Turns on the bow lights and the anchor light. This position will also
activate the red light in your compass.
Summary of Contents for 2010 23 XP
Page 2: ...ii...
