13
Systems and Accessories
Electrical System
12 Volt Receptacle (Optional)
The 12-volt receptacle is installed on the console. It is easily accessible and can be used to charge your cell
phone, operate a hand held remote spotlight, etc.
Circuit Breakers
Circuit breakers and/or fuses protect the wiring. In the event a device stops working, check to see if the circuit
breaker is tripped or if the fuse is blown. Breakers are installed in the following locations:
The main breaker is located behind the hatch that is installed in the port aft corner of the cockpit.
Breakers and/or fuses for the aft bilge, stereo and accessory are located above the main breaker.
Additional breaker switches are also located on the switch panel below the individual switches.
A tripped breaker will protrude or move from its set position indicating that the circuit has been overloaded. Turn
off the device(s) on the circuit, then reset the breaker by pushing in once or by returning a breaker switch to the
on position. If the breaker does not reset or if it resets and then trips again after the device is turned back on,
then a short circuit exists or your device may be damaged, overloaded, or faulty. Correct the problem and then
reset the breaker.
If the breaker continues to trip and you are certain the device, switch and wiring are in good repair; either the
breaker is faulty or it is too small for the load. Reduce the load or replace the breaker.
Air Conditioner (Optional)
The installation of the air conditioner system included the following components:
Control knobs (mode and thermostat) are installed on the aft wall of
the cabin.
Air conditioning vent – One is installed on the aft wall of the cabin.
Another is installed in the cockpit at the helm.
Air conditioner return is installed next to the step on the aft wall of
the cabin.
Air conditioner unit is installed behind the air conditioner return.
Water pump and seacock are installed below the cabin floor and
are accessible via the round access pie next to the cabin step.
On/Off battery switch is installed behind the hatch that is located
next to the fire extinguisher holder.
Battery charger is installed behind the hatch that is located next to
the fire extinguisher holder.
Shore power inlet is installed in the port aft corner of the cockpit,
above the raw water washdown outlet.
Control knobs
(mode and thermostat)
To operate the air conditioner unit:
Ensure that the seacock (seawater intake ball valve) is open. The
seacock is open when the seacock lever is in the horizontal
position.
Turn the mode control knob to off.
Turn on the air conditioning unit circuit breaker.
Turn the mode control knob to fan. This energizes the fan.
Turn the thermostat control knob to the coolest position by rotating
it fully clockwise.
Air conditioner return
Summary of Contents for 2010 23 XP
Page 2: ...ii...