44
Service and Care
To enjoy trouble free use of your Pro-Line, follow the recommended procedures and instructions relating
to the service and care of your boat. Failure to follow proper maintenance practices will result in shorter
life of your equipment and may void your warranty.
Much of the installed equipment on your Pro-Line is warranted separately. Follow the care instructions
found in your owner’s packet to keep these individual warranties in force.
Your engine manual contains service information relating to your particular engine installation. Follow the
engine manufacturer’s recommendations for trouble free service and to preserve your warranty rights.
Your new Pro-Line boat is your home away from home. Generally, you should maintain your boat with
the same care as you would maintain your home or automobile. Many of the same products used in
caring for your home and automobile can be used to maintain your new boat.
Fiberglass and Gelcoat
The gelcoated fiberglass on your Pro-Line provides a smooth, easy to clean and maintain surface.
Regular cleaning and waxing will preserve the finish on your boat for many years to come.
Use a mild detergent and plenty of fresh clean water to swab down the exposed gelcoat on your boat. Do
not use harsh cleaners containing ammonia, chlorine, or abrasives. Do not use acetone or any ketone
solvents. Stubborn stains may be removed with alcohol or kerosene provided they are washed off
immediately and completely with a mild detergent and water.
Wax all gelcoat surfaces a minimum of twice a year, more often if the boat is stored in the sun. If
neglected, the surface will take on a dull appearance that is not restorable by waxing. Hand buff with a
rubbing compound such as Dupont No. 7, or power buff with Mirror Glaze No. 1. Then follow up with a
good waxing.
Caution: When power buffing, use care not to leave swirl marks or "burn" the surface.
You may want to leave power buffing to a professional.
The gelcoat on your Pro-Line is approximately 25-mil thick. Minor scratches and deep stains that do not
penetrate the gelcoat can be lightly wet sanded with 600 grit sand paper, buffed and waxed to remove.
If a deep gouge to the surface occurs that goes through the gelcoat and into the fiberglass, it must be
repaired promptly to avoid further damage. Your dealer is best equipped to handle this repair and
achieve good bonding and color match. There are many different gelcoat repair kits on the market for this
use. However, results obtained may not be satisfactory. See your Pro-Line dealer for fiberglass damage
deeper than 1/16 inch.
Epoxy Barrier Coat & Bottom Paint
If your boat will be in the water continuously, we recommend sealing the bottom of the hull with a high
quality barrier coating. Unsealed gelcoat may form water blisters. Repair of water osmosis blister
damage is not covered under the limited warranty.
The phenomenon of osmotic blistering is known to occur in saltwater, brackish water and/or fresh water.
Any boat left in the water for any period of time is susceptible. Nearly all the marine bottom paint
manufacturers today offer coatings that help protect the hull against blistering. If required, contact your
Pro-Line dealer’s Service Department or another qualified service professional for further information.
