4
MAINTENANCE
Wipe clean as needed. Use mild upholstery cleaner (not caustic) to clean seat as needed.
Do not
lubricate casters!
Figure 6 - Creeper configuration
3. Insert Lock Pin into hole in frame side. Check for proper operation.
4. Using the included open-end wrench, attach two Casters to the threaded holes in the Head
Frame section. Use a 5mm hex key to fasten the remaining four Casters to the Creeper
Frame. Insert the threaded Fasteners from the top and the Casters from the bottom, then
tighten with hex key.
OPERATING INSTRUCTIONS
1. Locate and unlock spring loaded Locking Pin for middle section by pulling out until disengaged.
Then rotate Head Frame and Middle Frame upward as shown in Fig. 4 until the Locking Pin
can engage hole in Creeper Seat locking plate (ensure Lock Pin is fully engaged). This is the
low seat configuration.
2. Disengage Lock Pin for Middle Frame and rotate further forward. Engage locking pin.
Disengage Lock Pin for Head Frame section and rotate backwards as shown in Fig. 5. Adjust
hinged caster brackets as required. This is the high seat configuration.
CAUTION
: Ensure all Lock Pins are properly engaged before using creeper.
3. Adjust hinged caster brackets so wheels will contact ground properly. Unlock spring loaded
Lock Pins, then reverse steps 1 and 2, as shown in Fig. 6, to convert Creeper Seat into
Creeper.
Figure 4 - Low seat configuration
Figure 5 - High-seat configuration
