Pro-Lift T2151, Owner'S Manual

Page: 6 / 6

6
TROUBLESHOOTING
Symptom Possible Causes Corrective Action
Hydraulic unit will not lift load
• Release valve not tightly closed
• Overload condition • Ensure release valve tightly closed
• Remedy overload condition
Hydraulic unit bleeds off after lift
• Release valve not tightly closed
• Overload condition
• Hydraulic unit malfunction • Ensure release valve tightly closed
• Remedy overload condition contact
• K/M Australia
Lift will not lower after unloading
• Reservoir overfilled
• Linkages binding • Drain fluid to proper level
• Clean and lubricate moving parts
Poor lift performance
• Fluid level low
• Air trapped in system
• Ensure proper fluid level
• With ram fully retracted, remove oil
filler plug to let pressurized air es-
cape, reinstall oil filler plug
Will not lift to full extension • Fluid level low • Ensure proper fluid level
REPLACEMENT PARTS
When ordering replacement parts, please refer to the model number / serial number found on the product, then give
the part number and description.
Available Parts: Not all components of the lift are replacement items, but are illustrated as a convenient reference of
location and position in the assembly sequence.
Model T2151
Part No. Description Quantity
1 Front wheel assembly 2
2 Rear caster assembly 2
3 Hydraulic unit assembly 1
4 Oil filler plug 1
5 Locking lever assembly 1
6 Handle 1
-- Tie-down Strap (not shown) 2
-- Complete hardware kit (not shown) 1
-- Labels 3
-- Owner’s manual 1
1
2
4
3
5
6