5
(fig. A)
(fig. B)
Strap
Press to Loosen Strap
Pull Lever to Tighten
HOW TO USE TIE-DOWN STRAP
1. After lifting the load (e.g. a motorcycle). Secure it with the provided tie-down strap. Make sure the strap is threaded
into four strap holders as shown in below figure.
2. To tighten the strap, thread the strap into the ratchet tie-down and pull the lever (open). Close and open the ratchet
tie-down until the strap is fully tightened and the load is secured (see fig. A).
3. To loosen the strap, simply press the spring clip (see fig. B).
CARE AND MAINTENENCE
NOTE: When lift is not in use, lifting arm should be stored in the fully retracted position. Keep lift clean and well
lubricated. Apply a couple of drops of light machine to all pivoting joints as needed. Thoroughly wipe up excess oil
to help prevent slipping and falling.
TO CHECK AND ADD HYDRAULIC OIL
1. To check hydraulic oil level, remove unit from lift, stand unit upright on a stable, level surface. Remove oil filler
plug. Oil should be to the level of the oil filler plug hole.
2. If low, add high quality hydraulic jack oil ONLY. Never use ANY other fluid. Use of other fluid may result in hydraulic
system failure, causing sudden and unexpected loss of load height.
3. Install oil filler plug, install hydraulic unit into receiver of lift. Secure with provided bolt.
NOTE: To get the longest life possible out of your lift, we recommend changing the hydraulic oil after 7 years of use,
sooner if used in a dust and grit filled environment. Do not expose to moisture. Dry lift completely if it gets wet. Check
pump piston and ram of hydraulic unit periodically for signs of rust and corrosion. Clean mildly affected areas with a
clean oily cloth. Never use abrasives on the pump piston and ram surfaces.
TO REPLACE HYDRAULIC OIL
1. Remove hydraulic unit from lift. Stand unit upright on a stable, level surface. Remove oil filler plug and drain old
oil into a suitable container.
2. Fill with high quality hydraulic jack oil.
NOTE: Dispose of used hydraulic oil in accordance with local regulations.
TO PURGE TRAPPED AIR FROM SYSTEM
1. Fully lower the lift arms, leave release valve open.
2. Remove oil filler plug. As you remove the oil filler plug you may hear pressurized air escaping from the reservoir.
This means you have successfully purged trapped air from the system.
3. Install oil filler plug.
