© Audio Trade GmbH · Pro-Ject Debut Carbon/Phono USB / Ortofon OM10 · Revision 2013.11.15
7
Technical specifications Pro-Ject Debut Carbon Esprit / Pro-Ject 8.6cc
Nominal speeds
33/45 r.p.m.
Speed variance
±0,8 %
Wow and flutter
±0,1%
Signal to noise
68dB
Effective tonearm mass
6g
Effective tonearm length
8,6 " ( 218,5mm)
Overhang 18,5mm
Power consumption
7,5W, 0W in Stand-By
Voltage
suitable for your country's mains supply
Dimensions (W x H x D)
415 x 118 x 320mm, dust cover open 415 x 365 x 405mm
Weight 6kg
Technical specifications moving magnet phono pre-amplifier - A/D converter
* typical for MM or high output MC cartridges
Input capacitance/input impedance 47kohms/100pF *
Gain 32dB
Output voltage typically
200mV/1kHz at 5mV
Noise floor
-88dB
RIAA-equalisation curve accuracy
20Hz-20kHz / max. 0,5dB
USB output
digital serial data protocol USB 1.1
Operating systems
Windows XP
®
, Windows VISTA
®
, Windows 7
®
, Windows 8
®
,
Mac OS
Technical specifications MM-Cartridge Ortofon OM 10
Frequency range
20-22.000Hz
Channel separation
22dB /1kHz
Output voltage
4mV
Recommended load impedance
47kohms / amplifier connection – MM-input
Compliance/stylus type
25
m/mN – elliptical
Recommended tracking force
15mN
Weight 5g
Potential incorrect use and fault conditions
Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls before
leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but
can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common
fault symptoms is included.
The platter doesn't turn although the unit is switched on:
The unit is not connected to the mains power supply.
No mains at the socket.
Drive belt is not fitted or has slipped off.
No signal through one or other channel or both channels:
No signal contact from the cartridge to the internal tonearm wiring or from that to the arm lead or
from that to the phono box or between that and the amplifier. This could be due to a faulty plug,
broken wire or solder joint or simply loose plug/socket connection.
Wrong input selected at amplifier.
Amplifier not switched on.
Amplifier or speakers defective or muted.
No connection to the loudspeakers.
Distorted or inconsistent sound from one or both channels:
Record player is connected to wrong input of amplifier, or MM/MC switch incorrectly set.
Needle or cantilever damaged.
Wrong r.p.m., drive belt overstretched or dirty, platter bearing without oil, dirty or damaged.
