20
Most treadmill problems can be solved by following
the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assis-
tance is needed, see the front cover of this manual.
SYMPTOM: The power does not turn on
a. Make sure that the power cord is plugged into a
surge suppressor and that the surge suppressor is
plugged into a properly grounded outlet (see page
13). Use only a surge suppressor that meets all of
the specifications described on page 13.
IMPORTANT: The treadmill is not compatible
with GFCI-equipped outlets and may not be
compatible with AFCI-equipped outlets.
b. After the power cord has been plugged in, make
sure that the key is inserted into the console.
c. Check the power switch located on the treadmill
frame near the power cord. If the switch protrudes
as shown, the switch has tripped. To reset the
power switch, wait for five minutes and then press
the switch back in.
SYMPTOM: The power turns off during use
a. Check the power switch (see the drawing above). If
the switch has tripped, wait for five minutes and
then press the switch back in.
b. Make sure that the power cord is plugged in. If the
power cord is plugged in, unplug it, wait for five
minutes, and then plug it back in.
c. Remove the key from the console, and then
reinsert it.
d. If the treadmill still will not run, please see the front
cover of this manual.
SYMPTOM: The console displays remain lit when
you remove the key from the console
a. The console features a display demo mode, de-
signed to be used if the treadmill is displayed in a
store. If the displays remain lit when you remove
the key, the demo mode is turned on. To turn off
the demo mode, hold down the Stop button for a
few seconds. If the displays are still lit, see THE
INFORMATION MODE on page 18 to turn off the
demo mode.
SYMPTOM: The incline of the treadmill does not
change correctly
a. Hold down the Stop button and the Speed increase
button, insert the key into the console, and then re-
lease both buttons. Next, press the Stop button,
and then press the Incline increase or decrease
button. The treadmill will automatically rise to the
maximum incline level and then return to the mini-
mum level. This will calibrate the incline system. If
the incline system does not begin calibrating, press
the Stop button, and then press the Incline in-
crease or decrease button again. When the incline
system is calibrated, remove the key from the
console.
SYMPTOM: The displays of the console do not
function properly
a. Remove the key from the console and
UNPLUG
THE POWER CORD.
Then, remove the two #12 x
1 1/4" Screws (27) and the two #8 x 3/4" Hood
Screws (24) and carefully remove the Motor Hood
(62).
TROUBLESHOOTING
Tripped
Reset
c
24
27
27
62
a
All manuals and user guides at all-guides.com
