17
HOW TO USE A PRESET WORKOUT
1. Insert the key into the console.
See HOW TO TURN ON THE POWER on page 15.
2. Select a preset workout.
To select a preset
workout, press the
Workout Select button
repeatedly until the
number of the desired
workout appears in the
display. When you select a workout, the maximum
speed and incline settings of the workout will flash
in the displays for a few seconds; then the display
will show how long the workout will last. A profile of
the speed settings of the workout will scroll across
the matrix.
3. Start the walking belt.
Press the Start button or the Speed increase but-
ton to start the workout. A moment after you press
the button, the treadmill will automatically adjust to
the first speed and incline settings for the workout.
Hold the handrails and begin walking.
Each workout is divided into 30 one-minute seg-
ments. One speed setting and one incline setting
are programmed for each segment. Note: The
same speed and incline settings may be pro-
grammed for consecutive segments.
During the workout, the
profile will show your
progress. The flashing
segment of the profile
represents the current
segment of the work-
out. The height of the
flashing segment indi-
cates the speed setting for the current segment. At
the end of each segment, a series of tones will
sound and the next segment of the profile will begin
to flash. If a different speed and/or incline setting is
programmed for the next segment, the speed
and/or incline setting will flash in the display to alert
you. The treadmill will then automatically adjust to
the speed and incline settings for the next segment.
When you use a weight
loss workout, the con-
sole will prompt you to
use the dumbbells for a
full-body crosstraining
workout. When the
dumbbell indicator on the console lights, pick up
the dumbbells and continue to walk or run holding
the dumbbells. When the indicator turns off, set the
dumbbells down and continue your workout.
Exercises using dumbbells should be at-
tempted only by experienced users.
The workout will continue in this way until the last
segment of the profile flashes in the display and
the last segment ends. The walking belt will then
slow to a stop.
If the speed or incline setting for the current seg-
ment is too high or too low, you can manually over-
ride the setting by pressing the Speed and Incline
buttons;
however, when the current segment of
the workout ends, the treadmill will automati-
cally adjust to the speed and incline settings
for the next segment.
To stop the workout at any time, press the Stop
button. To restart the workout, press the Start but-
ton or the Speed increase button. The walking belt
will begin to move at 1 mph. When the next seg-
ment of the workout begins, the treadmill will auto-
matically adjust to the speed and incline settings
for that segment.
4. Follow your progress with the displays.
See step 5 on page 16.
5. Measure your heart rate if desired.
See step 6 on page 16.
6. When you are finished exercising, remove the
key from the console.
See step 7 on page 16.
Current Segment
All manuals and user guides at all-guides.com
