11
15. Lift the latch on the underside of the Left Pedal
Leg (14), and set the Left Pedal Leg on the left
Crank Bushing Sleeve (43). Release the lever, and
make sure that the Left Pedal Leg is securely con-
nected to the Crank Bushing Sleeve.
Connect the Right Pedal Leg (not shown) in the
same way.
See step 6
. Tighten the M8 x 70mm Button Bolt
(80) and the two M8 x 23mm Patch Screws (84).
16.
Make sure that all parts of the elliptical exerciser are properly tightened.
Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
Latch
15
43
14
14. Apply a thin film of grease to a Pedal Leg Axle (32)
and to the two Pedal Leg Bushings (33) in the Left
Pedal Leg (14).
Next, slide an M8 Washer (88) and a Pedal Leg
Cover (31) onto an M8 x 23mm Shoulder Patch
Screw (115), and finger tighten the Shoulder Screw
into the Pedal Leg Axle (32).
While another person holds the end of the Left
Pedal Leg (14) inside the bracket on the Left Upper
Body Arm (11), insert a Bearing Spacer (113) into
each side of the bracket. Next, insert the Pedal Leg
Axle (32) into the Left Upper Body Arm and the Left
Pedal Leg. Then, slide an M8 Washer (88) and a
Pedal Leg Cover (31) onto another M8 x 23mm
Shoulder Patch Screw (115), and tighten the
Shoulder Screw into the Pedal Leg Axle. Tighten
both Shoulder Screws.
Repeat this step to attach the Right Pedal Leg
(not shown) to the Right Upper Body Arm (12).
Grease
13
115
32
88
31 113
113
12
11
14
115
88
33—Grease
Bracket
31
