![background image](http://html.mh-extra.com/html/pro-form/pfccex01210-0/pfccex01210-0_user-manual_1605814016.webp)
16
Inspect and properly tighten all parts of the exercise
bike regularly. Replace any worn parts immediately. To
clean the exercise bike, use a damp cloth and a small
amount of mild soap—
never use alcohol, abrasives,
or chemicals to clean the exercise bike.
IMPORTANT: To avoid damage to the console,
keep liquids away from the console and keep the
console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, replace all the
batteries at the same time; most console problems are
the result of low batteries. To replace the batteries,
see assembly step 8 on page 8.
If the console does not display your heart rate when
you use the handgrip pulse sensor, see step 5 on
page 14.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first remove the left pedal by turning it clock-
wise with an adjustable wrench.
Next, remove the screws from the left and right
shields;
there are three sizes of screws in the
shields—note which size of screw you remove
from each hole.
Then, remove the left shield.
Locate the Reed Switch (21). Turn the Crank (13) until
a Magnet (16) is aligned with the Reed Switch.
Loosen, but do not remove, the indicated M4 x 16mm
Flange Screw (61).
Slide the Reed Switch (21) slightly closer to or away
from the Magnet (16) , and then retighten the M4 x
16mm Flange Screw (61). Turn the Crank (13) for a
moment.
Repeat these actions until the console displays correct
feedback. When the reed switch is correctly adjusted,
reattach the left shield and the left pedal.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is at the highest level, the
drive belt may need to be adjusted.
To adjust the drive belt, you must first remove the right
pedal and the right shield. Using an adjustable
wrench, turn the right pedal counterclockwise and
remove it.
Next, remove the screws from the left and right
shields;
there are three sizes of screws in the
shields—note which size of screw you remove
from each hole.
Then, remove the right shield.
Loosen the M10 x 22mm Bolt (45). Tighten the M8 x
38mm Hex Screw (69) until the drive belt is tight.
Then, retighten the M10 x 22mm Bolt (45). Reattach
the right shield and the right pedal.
MAINTENANCE AND TROUBLESHOOTING
16
21
61
13
45
69