22
HOW TO MAINTAIN THE EXERCISE BIKE
Inspect and tighten all parts of the exercise bike regu-
larly. Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild detergent.
IMPORTANT: To
avoid damage to the console, keep liquids away
from the console and keep the console out of
direct sunlight.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted.
To adjust the reed
switch, first
press
the power switch to
the off position and
unplug the power
cord.
Then, use a flat
screwdriver to remove
the Upper Shield (10)
from the exercise bike.
Locate the Reed Switch (35). Loosen, but do not
remove, the two #8 x 19mm Tek Screws (97).
Next, rotate the Crank Pulley (53) until a Magnet (55)
is aligned with the Reed Switch (35). Slide the Reed
Switch slightly toward or away from the Magnet. Then,
retighten the #8 x 19mm Tek Screws (97).
Plug in the power cord and press the power switch to
the reset position. Rotate the Crank Pulley (53) for a
moment. Repeat these actions until the console dis-
plays correct feedback.
When the reed switch is correctly adjusted, reattach
the upper shield.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, the drive belt
may need to be adjusted.
See the EXPLODED DRAWING on page 27 to iden-
tify the parts mentioned below.
To adjust the Drive Belt (66), first
press the power
switch to the off position and unplug the power
cord.
Locate the access hole in the underside of the
Right Shield (12). Using a hex key, tighten the Idler
Adjustment Screw (39) until the Drive Belt (66) is tight.
MAINTENANCE AND TROUBLESHOOTING
10
55
53
35
97
39
