4. Remove the knob from the pin. Make sure that the collar
and the spring are on the pin. (Note: If there are two col-
lars, place one on each side of the spring.) Insert the pin
into the Latch Insert (114) in the left Upright (97), and
tighten the knob back onto the pin.
114
Knob
Collar
Spring
Pin
97
4
7
TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please call the telephone number on the front
cover of this manual.
PROBLEM: The power does not turn on
SOLUTION:
a. Make sure that the power cord is plugged into a properly earthed outlet. (See page 10.) If an ex-
tension cord is needed, use only a 3-conductor, 1 mm
2
(14-gauge) cord that is no longer than 1.5
m (5 ft.). Important: The treadmill is not compatible with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is inserted into the console.
c. Check the circuit breaker located on the treadmill
frame near the power cord. If the switch protrudes as
shown, the circuit breaker has tripped. To reset the
circuit breaker, wait for five minutes and then press
the switch back in.
d. Check the on/off switch located on the treadmill
frame near the power cord. Make sure that the switch
is in the “on” position.
PROBLEM: The power turns off during use
SOLUTION:
a. Check the circuit breaker located on the treadmill frame near the power cord (see c. above). If the
circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. Make sure that the on/off switch is in the “on” position.
e. If the treadmill still will not run, see the front cover of this manual.
PROBLEM: The displays of the console do not function properly
SOLUTION:
a. Remove the key from the console and
UNPLUG THE
POWER CORD.
With the help of a second person,
carefully tip the Uprights (97) down as shown. Remove
the five Hood Screws (44). Note: A phillips screwdriver
with a shaft at least 127 mm (5 in.) long is required.
44
44
44
97
a
Tripped
c
Reset
On
Position
d
2. With the help of a second person, carefully tip the
Uprights (97) down as shown. (Note: It may be helpful to
place one foot against one of the Extension Legs [115]
as you tip the Uprights.)
Make sure that the Extension
Legs remain in the Uprights.
Attach each Extension Leg (115) with two Extension Leg
Bolts (80) and two 1/4” Washers (39) as shown.
80
115
80
80
115
97
39
39
2
39
39
3. Attach the four Base Pads (99) to the base of the
Uprights (97) with four 1” Tek Screws (40).
With the help of a second person, raise the Uprights (97)
back to the vertical position.
40
40
97
99
99
3
40
99
26
99
40
