Pro-face LT series, Hardware Manual

Page: 79 / 143

LT-4201TM/4301TM Hardware Manual
79
Connecting the Power Cord
The table explains how to connect the power plug:
NOTE:
z
Do not solder the wire directly to the power receptacle pin.
z
The power supply cord must meet the specification shown above. Twist the
power cords together, up to the power plug, for EMC compliance.
z
Use field wiring terminal marking for wire type (75
°
C (167
°
F) copper conductors
only).
Step Action
1 Confirm the power cord is not connected to the power supply.
2 Check the rated voltage and remove the "DC24V" sticker on the DC power
supply connector.
3 Remove 10 mm (0.39 in.) of the vinyl membrane off the ends of the power code
wores.
4 If using stranded wire, twist the ends. Tinning the ends with solder reduces risk
of fraying and ensures good electrical transfer.
5 Push the Opening button with a small and flat screwdriver to open the desired
pin hole.
6 Insert each pin terminal into its corresponding hole. Release the Opening button
to clamp the pin in place.
7 After inserting all three pins, insert the power plug into the power connector on
the LT.
9 '&3RZHU&RUG
2SHQLQJ%XWWRQ
9
)*