4
Installation
■
Attach the GP's Installation Fasteners from inside the panel.
Tighten the installation fasteners with a standard screwdriver.
Tightening the fastener screws with too much force can damage the
GP's case. The torque necessary to ensure a waterproof seal is 0.5 to
0.6N•m.
156
under 4-R3
123.5
Panel thickness should be
from 1.6mm to 5.0mm
Unit: mm
+1
0
+1
0
GP Unit
■
Cut a hole in the metal panel according to the dimensions given below.
Insert the GP into the panel from the front of the panel.
Metal Panel
Please be sure the gasket has been installed on the GP before
installing the GP.
Follow the steps given below when installing the GP unit.
■
■
■
■
■
Confirm the Moisture Resistant Gasket’s Seating
Moisture resistant
gasket
It is strongly recommended that you use
the gasket. When seating the gasket,
place the GP on a level surface with the
display panel facing downward. Check
that the GP’s moisture resistant gasket is
seated securely into the gasket’s groove,
which runs around the perimeter of the
panel’s frame.
Rear face
