Pro-face GP-4200 Series, Hardware Manual

Page: 230 / 241

230
3 Slowly peel the protective sheet off of the GP unit's screen.
Note: Peeling off the protective sheet with excessive force may peel off the film
of the touch panel.
4 When the GP unit is shipped from the factory, installation brackets are fixed to
its top surface and bottom surface. This corresponds to the standard mount ori-
entation. If you are installing the GP unit in a panel with the GP unit in the same
state as when it was shipped from the factory, read step 8.
If you are switching the installation brackets to their positions on the sides of
the GP unit or if you are installing the GP unit with the flat mount orientation,
read steps 5 to 7.
5 [Switching the installation brackets to their positions on the sides of the GP unit
or changing to the flat mount orientation]
Orient the GP unit so that its screen faces down, and then place the GP unit on
a clean and level surface.
6 Use a Phillips head screwdriver to remove the two installation screws fixing the
one installation bracket in place on the top surface of the GP unit. In the same
manner, remove the one installation bracket from the bottom surface.
7 Attach the installation brackets to the top and bottom surfaces of the GP unit
or to the sides of the GP unit. In each case, attach the surface of the installation
bracket that has six open holes to the GP unit. Note that the protruding parts
and the fixation positions of installation screws vary between the standard
mount (figure A) and flat mount (figure B) orientations. Use a Phillips head
screwdriver to fix in place two installation screws per installation bracket. The
tightening torque is 0.8 N•m (7.1 lb-in).
A) Standard mount
1) Use two installation screws to fix the bracket in place. (Use the two inner
holes.)
B) Flat mount
2) Use two installation screws to fix the bracket in place. (Use the two outer
holes.)
Note: Check the positions of the protruding parts. Depending on the installa-
tion method, the positions of these parts may differ from the positions indicated
by the arrows in the figure.
Step Procedure Details
$
%