P
P
r
r
o
o
-
-
B
B
e
e
l
l
L
L
t
t
d
d
T
T
e
e
c
c
h
h
n
n
i
i
c
c
a
a
l
l
m
m
a
a
n
n
u
u
a
a
l
l
H
H
U
U
-
-
F
F
r
r
e
e
e
e
w
w
a
a
y
y
R
R
a
a
n
n
g
g
e
e
S
S
y
y
s
s
t
t
e
e
m
m
U
U
s
s
e
e
r
r
G
G
u
u
i
i
d
d
e
e
4
4
9
9
D
D
a
a
t
t
a
a
b
b
a
a
s
s
e
e
m
m
o
o
d
d
e
e
The controller uses the editable database when sw2_7 is in CONFIGURE mode and
uses the default database when sw2_7 is in FIXED mode.
When sw2_7 is in the CONFIGURE position, changes made to the configuration of the
system via the editor port will be saved in the editable database. The controller will
use the editable database to effect changes to the router set-up.
When sw2_7 is in the FIXED position, changes to the configuration via the editor port
will be saved in the editable database. The default database will be used to effect
changes to the router set-up.
D
D
a
a
t
t
a
a
b
b
a
a
s
s
e
e
t
t
r
r
a
a
n
n
s
s
f
f
e
e
r
r
A database transfer is only invoked by a ‘DT’ command from the Editor port. Note
that this command is only available with the terminal editor. Database transfer will
only occur from active to idle card.
A database transfer includes a transfer of:
·
the editable database
·
tally table data for the number of destinations and levels configured
·
protect data table
·
router parameters
·
installed modules in the configured system
WARNING: Do not press the reset button on the active card whilst
transferring databases. The database update takes several minutes, and if
the reset is pressed during this time ALL DATABASE SETTINGS WILL BE LOST,
and the default database loaded.
Commands from the editor are only processed by the active controller. The idle
controller ignores all commands. A database transfer must be initiated to make
active and idle configurations identical.
Messages on Editor screen will indicate database transfer progress.
To swap the active/idle status between two controllers press the RESET button on the
active card. The idle card now becomes the active card and vice versa.
