Operating instructions SPEEDY 4all & 4you & 4teen
51
To
install
the push handles, place these in the
back tube and insert the M6 fixing screws (AF
4 mm) (with washer) into the each of the holes
of the back tube and push handle. Tighten the
M6 fixing screws (AF 4 mm) to 7 Nm torque
and secure them with thread lock fluid.
26.3 Push handles, horizontally
screwed in back tube
Figure 152: Push handles, horizontally screwed in
back tube
It is not possible to adjust these push handles.
To
remove
the push handles, turn these
counter-clockwise out of the back tube.
Figure 153: Screw the push handle horizontally out
of the back tube
To
install
the push handle, turn it into the back
tube clockwise and tighten it to a maximum
hand tightness.
26.4 Safety push handles with
continuous height adjustment
Figure 154: Safety push handles with infinite height
adjustment
For
adjusting the height
of the push handles,
open the clamp lever by turning counter-
clockwise (a half to a complete rotation). Then
the height of the push handles can adjusted.
The height can be infinitely adjusted. We
recommend adjusting both push handles to the
same height. Once the desired height is set,
hold the push handles in this position and then
close the clamp lever again clockwise with a
half to complete rotation.
If the clamp lever knocks against the frame
when turning the push handle, you have the
option of pulling the clamp lever out vertically
to the rotating axis and to let go into another
angled position via the integrated serration,
and keep on turning. This also permits the
position of the clamping lever to be aligned to
the back tube after performing the height
setting ao that this does not protrude over the
back tube to the side.
Open
Close
Turning out
