Operating instructions SPEEDY 4all & 4you & 4teen
43
pliers). After removing the M6 fixing screw, the
tension spring can be removed.
Figure 122: M6 fixing screw and tension spring
removed from the anti-tipping bar
Figure 123: M6 fixing screws with radius discs and
footstep pin
There is an inlet within the anti-tipping bar that
must be adjusted to the new height position.
Where possible, the inlet should be positioned
in the anti-tipping bar as low as possible. A
screwdriver could be used for the positioning of
the inlets, for example.
Figure 124: Inlet of the anti-tipping bar and the
screwdriver
Now the tension spring is positioned in the inlet
so that the end eyes of the tension spring are
positioned precisely over the borehole in which
the M6 fixing screw shall then be screwed in
to. Once the inlet and the tension spring have
been positioned correctly, the M6 fixing screw
(with both radius discs and the footrest pin)
(AF 4 mm) is crewed into the new height
position through the inlet and the end eyelet of
the tension spring.
Finally, reattach the anti-tipping support to the
product as described in chapter 24.2.
The anti-tipping support has been
designed exclusively to minimize the risk of
tipping over backwards. It is not suitable for
reducing the risk of tipping forwards or to the
side. There is no safety equipment on offer for
minimizing these risks. For this reason,
handling these risks need to be learnt in
cooperation with your therapists and doctors.
Before using the product, after every load
on the anti-tippers and after every adjustment
to the product, make sure that the anti-tippers
are fully functional. In this case, it must not be
possible to swivel the anti-tippers to the side
when in operating position without having to
unlock them first. Moreover, the lower edge of
the anti-tipper wheels may not be any more
than 5 cm from the ground. If a larger gap is
required or necessary, then you need to work
with your therapists and doctors to practice
and learn to handle the increased risk of
tipping.
Tension springs
with cord
M6 fixing
screw with
footstep pin
Radius discs
M6 fixing screw
Footrest pins
Inlet
