3
4
B. The Using Attention
1. The outlet of the power supply must have the same voltage as the local area.
2. Be sure the transmitter and the receiver were connected to power supply.
C. Panel Controls and Features of Universal Type
The following illustrations show the names of each component on the transmitter and
receiver.
3. In some situation, there are two or more equipment is used within 50m at the
same time, perhaps the equipment may not work well.
4. Please do not use another one which operation frequency is similar to when
the equipment is working.
5. To make the remote control face to the transmitter’s IR Remote control window, and the
receiver’s IR remote control window (or extender accessory) to the source equipment,
the IR remote distance should be in the specified range.
6. The LED of the receiver and the transmitter’s IR remote control window would flash if
receiving the remote control signal when there is not harmful interference in
the ambient.
Caution: If the receiver’s indication LED flashes when the transmitter is not
FRONT VIEW FOR TRANSMITTER AND RECEIVER
infrared passes through
Remote control window
this to remotely control
REAR VIEW FOR TRANSMITTER AND RECEIVER
operating, it indicates there is interference in the environment. Then
perhaps, you can’t control the system so well.
DC Power Input
Power Switch
IR Extender
433MHz ANT Power Switch
433MHz ANT
DC Power Input
