PANEL LAYOUT
Transmitter (TX)
Receiver (RX)
PANEL DESCRIPTION
1. Link LED
This LED indicator will flash once Cat.6 cable has been properly connected between the
Transmitter and Receiver unit. Once both devices are connected and powered up this
LED will stop flashing and stay on to indicate successful connection between
Transmitter and Receiver.
2. Power LED
This LED indicator will activate once the included 5V DC power adapter has been
properly connected between the Transmitter & Receiver unit and a power socket.
Note: the LED will blink during the initial power up time during which it is loading the
device firmware.
3. HDMI IN
Connect one HDMI cable between this port and HDMI output port of the source device
(DVD, Set-top box, blue-ray DVD)
4. HDMI Out
Connect one HDMI cable between this port and HDMI input port of display device
5. IR Receiver
Connect the IR Receiver cable to this port. Output device can be controlled from the
location of this Transmitter or Receiver unit by way of its original IR remote control or a
universal type IR remote control.
6. IR Blaster
Connect the IR Emitter Cable to this IR port and place the connected IR emitter module
on the IR Extender zone of devices
7. DC 5V
Connect 5V DC power supply to this port.
8. RJ45
Connect one 100Ohm Cat.5e/Cat.6 cable between RJ45 Port of Transmitter and
Receiver unit.
