Technical manual August 2009
Rev: 01/08/09
Page:
28
LCD Display & Programming Functionality
−
In any ‘Default display mode’, if the unit is in the charging station the hoist will go into
Charging Display Mode regardless what the user has selected as ‘Default Display
Mode’. Charging Display Mode should over-ride Low Battery Mode.
−
The hoist will then:
7.
Display a flashing “Charging” with the percentage charged (in 10% increments)
in the top row of the display (e.g., “Charging 60%”).
8.
Show the appropriate number of fully blackened out cells, with the remaining
cells in the bottom row flashing.
•
To enter programming mode:
−
Hold the ‘Up’ and ‘Down’ buttons simultaneously for three (3) seconds.
−
The hoist will then:
9.
Beep three (3) times. Display a flashing “Entering Programming Mode” for two
(2) seconds.
10.
Go to the first programming option.
−
If the user continues to hold the ‘Up’ and ‘Down’ buttons for longer than the display
flashes, “Entering Programming Mode”, the unit will exit the programming mode.
•
To exit programming mode:
−
If no buttons are pressed for ten (10) seconds the unit exits the programming mode
automatically. The hoist should then:
11.
Beep three (3) times. (the beep should be as loud as the existing emergency
down alarm)
12.
Display a flashing “Exiting Programming Mode” for two (2) seconds.
13.
Go back to the standard display mode.
•
Programming Mode:
−
Whenever in Programming Mode, the top line of the display should read, “PROGRAM
MODE”. Depending on what is being programmed, the second line should then change:
P R
G
M O
E
M
D
O
R A
D i s p l a
x
y
B A T
−
Using the ‘Up’ and ‘Down’ buttons, the user should then be able to cycle through their
choices.
%
C
h
a
g
i
n
0
5
r
g
Flashing
Flashing
