280400 / 280401 -
A320B
- Owner’s Manual
Rev: 07-2013
Page: 13
Assembly Instructions:
13. Connect all the cables to the control box as shown in the picture below.
A. Connect the Hand Control connector to the large circle on the left side of the control box as shown in
the Figure 26.
B. Connect the LA44 Actuator Cable connector to the second circle (Marked No. 1) from the left side of
the control box as shown in the Figure 27.
C. Connect the LA28 Leg Spreading Actuator Cable connector to the third circle (Marked No. 2) from the
left side of the control box as shown in the Figure 28.
D. Connect the Mains Cable/Power Cord to the rectangular outlet on the control box as shown in the Figure
29.
14.
Please make sure to charge battery before initial use and before each operation of floor hoist.
Figure 26
Figure 27
Figure 28
Figure 29
After assembly, check to ensure that:
1. Lifting actuator moving up and down with the buttons on the hand control, and control box.
2. Emergency lowering (mechanical, and electrical) functions works properly.
3. Rear wheel brakes works properly.
4. Leg spreading actuator works properly.
5. Batteries are fully charged.
