Priorit PRIODOOR ETX-RDA, Assembly And Operating Instructions Manual

Page: 9 / 21

9
Installing the door element

Turn the door element into the installation
position and place it in front of the wall
opening.

Route the connection cable hanging on the
lock side towards the front and let it hang.

Lift the door element into the wall opening
and place on the protruding packer
material at the bottom.

Firstly, the door frame must be pushed
against the bottom side packer material.

Align the door element flush with the
mounting frame, secure it against falling
out and tilting.

The four bottom countersunk head screws
4.5 x 80mm are then tightened and then
the frame is aligned using the cross-line
laser.

Use the countersunk head screws 4.5 x
80mm to screw the remaining frame of the
door element onto the mounting frame.

After screwing the frame onto the
mounting frame the door leaf can be
opened.

A power adapter with 24V or a test device
is required for this. White cable +24V,
brown cable -24V.

Screw the nameplate onto the mounting
frame, in the middle of the opening side,
using a panhead screw 4.5 x 20mm.

After the functional test, lay the connection
cable in the shaft between the mounting
frame and the wall (see detail below).

Fill the wall edge joints with mortar or
gypsum (e.g. Knauf Uniflott) depending on
the wall type.
connecting
cable