INSTALLING STREET WRAP GEN 2™ INTO MOUNTING BRACKETS
Connect wires from one section to another using red butt splice wire connectors, silicone filled wire
nuts or TE connectors. No more than two (2) 96” units in a series.
Lay the section being added on the mounting brackets. After making wire connections, tuck the wires
and connectors BEHIND the base track. Caulk notch.
Place track with LEDs, but no lens, over mounting brackets and press firmly, until securely snapped in
place.
Bring Street Wrap™ sections close together by pushing sections together, leave a 0.1875” approximate
expansion gap between track sections.
Install Lens on LED base.
Install an End Cap at the beginning and end of runs with silicone.
Finish by clipping a middle connector over both sections. Use a small amount of silicone.
1.
2.
3.
4.
5.
6.
Push LED base onto mounting bracket.
Base
Mount
Installed properly.
7.
3
