STREET WRAP GEN 2™ MOUNTING BRACKET LAYOUT
1.
Use a chalk line, gauge, laser level, or other means to be certain the run is straight, marking locations for brackets.
Install three (3), evenly spaced, mounting brackets per section. Ensure there are at least two inches between the end
of the track and the mounting bracket as shown in the picture above.
Use a 0.125” drill bit to add a drain hole in lens in the center of the run. Never drill drain hole when installed on the
LED base.
2.
3.
Note: There must be a 0.1875” space left between each section when using middle or corner connectors.
NOTE: MAXIMUM 4 UNITS PER 96W POWER SUPPLY
120 or 277 VAC
96W Power Supply
384”
96”
2
4.375”
