Princess 535596, Instructions For Use Manual

Page: 7 / 40

7
Step 3. Side of the head
Use the shorter settings of comb attachment for cutting the sideboards - the hair directly in front of the
ears. After that, adjust the comb attachment to a longer length and continue cutting to the top of the head.
Step 4 Top of the head
Use comb attachment to cut the hair on the top of the head from back to front against the direction of
growth of the hair. In some cases you may have to work from front to back. The comb attachment is to
make short, cropped hair. If you want to keep the hair on top of the head longer, you must use a comb to
keep the hair above the head. Cut with the clippers above the comb, or hold the hair between the fingers
and cut it off at the desired length. Always work from the back of the head. Gradually cut the hair shorter
by reducing the distance between the comb, or the fingers, and the head. Use the comb regularly to check
whether there are any uneven locks and to comb out cut-off hair.
Step 5 The finishing touch
Finally, for a good, accurately finished cut, remove the comb again and turn the clippers over (with the
bottom side up), so that you can touch up the bottom of the neck area, the sides and the area around the
ears. Put the adjustable cutting length button onto the lowest setting. Hold the clippers at a right angle to
the head, with the points of the cutting blade lightly touching the skin, and work in a downward direction.
This will produce just as smooth a result as if you had used a razor-blade.
Cutting longer hair
If you want the hair tapered, then first part and comb the hair as usual. Now divide the hair on the head
from behind into three equal parts around the head. Fix the two upper layers with pins, so that they will
not be in the way when you cut the lowest layer. After that, proceed to cutting with a pair of scissors or
with the help of the clippers in combination with the styling comb.
Thinning out your hair/beard
First attach comb attachment to the clipper and set the desired hair length, then slide the thinning regulating
button on the front side of the clipper to the left. Then you can cut your hair/beard thin.
CLEANING AND MAINTENANCE
After each use remove hair clippings with the cleaning brush.
You can clean the outside of the clippers with a soft, damp cloth.
The shaving head can be detached from the clipper. Clean the shaving head by rinsing it under a water tap.
However, the clipper unit and adaptor can’t be immersed in water.
How to remove the shaving head
Press the shaving head with your thumb towards the back and remove it.
Reinsert the shaving head by inserting the clip of the shaving head into the groove of the casing, and
press the shaving head back into the casing until it clicks