Princess 212700, User Instructions

Page: 15 / 105

10 Article 212700 Princess Food Processor and Blender
2 Place the mixing bowl on the drive unit.
Rotate the mixing bowl clockwise as far
as possible.
3 Place the accessory shaft (without the
knife) over the drive shaft in the mixing
bowl.
4 Place the slicer or the grater/shredder
on the accessory shaft, making sure the
side to be used is facing upwards.
Be careful when attaching and
removing accessories. The grater/
shredder is sharp.
5 Place the lid on the mixing bowl and
rotate the lid clockwise as far as
possible. The lid’s protruding lip must
be slid over the mixing bowl’s handle.
6 Pull the power cord out of the storage
space at the rear of the drive unit.
7 Insert the plug into the wall socket.
When all indicator lights are flashing,
the mixing bowl and/or the lid is not
fitted correctly. For safety reasons it is
not possible to switch on the appliance.
Check the position of the bowl and the
lid.
When the mixing bowl and the lid are
fitted correctly, only the stand-by
indicator light flashes. Only then the
appliance can be operated.
8 Press the I button for continuous low
speed. The stand-by indicator light will
dim and the blue indicator light in the
I button will be lit.
9 Add ingredients during use via the filling
opening in the lid. Use the stopper to
push solid ingredients downwards
through the filling opening. Do not push
too hard.
• The maximum operating time in
continuous high or low speed is
2 minutes. Then the drive unit will be
switched off automatically for
2 minutes. 15 seconds before
switching off the stand-by indicator
light starts flashing. The blue indicator
light stays on.
• To avoid personal injury or damage to
the appliance, never insert a hand or
another object into the mixing bowl
whilst the appliance is being used.
• Always use the stopper to push
ingredients. Never use your fingers, a
fork or another object to push
ingredients.
10 Switch the appliance off after use
(press the I button with the lit indicator
light).
11 Unscrew the mixing bowl and remove it
from the drive unit. Remove the
accessories from the bowl before
emptying.
Blending
1 Place the appliance on a flat, stable
surface where it cannot fall.
2 Place the blender jug on the drive unit.
Rotate the blender jug clockwise as far
as possible.
3 Cut the fruit and/or vegetables into
pieces that fit in the jug. Do not cut into
pieces that are too large, since they will
need to be small enough to fall to the
base of the jug.
4 Open the lid by turning it anti-clockwise,
and put the pieces in the jug.
See figure 3.
5 Fit the lid back onto the jug to prevent
splashing.
6 Insert the plug into the wall socket.
When all indicator lights are flashing,
the jug is not fitted correctly. For safety
reasons it is not possible to switch on
the appliance. Check the position of the
jug.
When the jug is fitted correctly, only the
stand-by indicator light flashes. Only
then the appliance can be operated.