NOTE:
In the event the receiver switch does not receive a transmitter signal when the BST change is scheduled to occur, the
switch will automatically adjust the time on the transmitter. In areas that do not observe BST this feature must be
disabled on the circuit board of the switch.
1. Disconnect the receiver switch from the Satellite Transmitter.
2. On the Receiver Switch remove the access cover and change dip switch #5 to the “ON” position, as shown in Figure 7
Figure 7: Receiver Switch with Cover Removed
Primex Wireless
Satellite Installation & User Guide
14
Special Circumstances - BST Time not Observed
