DRAFT
4. Route GPS cable and connect to Transceiver GPS connection.
Step 8: Weatherproof and secure antenna cabling
During this step, you will weatherproof and secure the cabling, verify all connections are secure, and caulk any exterior holes.
1. Weatherproof the antenna connection using GelWrap kit supplied.
2. Secure the GPS cable and LMR 400 cable to the building and mast.
3. Leave a drip loop where both cables enter the building to prevent water from entering the building.
4. Use UV resistant zip ties to secure the cables to the mast and building.
WARNING
Do not zip tie the GPS cable to the LMR 400 cable. These two cables must be 2 in. (5.08 cm) apart at all times, with the
exception of the point where they enter into the building.
5. Verify all nuts and bolts in the mounting hardware are secure.
6. Caulk all exterior holes.
7. Secure and tie wrap all indoor cables.
Step 9: Ground Transceiver
1. Connect and tighten the terminal ground lug (supplied) on the Transceiver.
2. Insert and tighten #6 gauge wire (supplied) into the Transceiver terminal ground lug.
3. Connect other end of wire to a verified building/earth ground source.
23
