A
B
Step 3: Mount sensor
Mount sensor using either of the methods below.
Method
Steps
Wall mount
Key-hole mount (A)
1. Determine the mounting location by referencing the key-hole slot located on the back of the device. Pre-drill mounting hole
into the wall surface and insert wall anchor.
2. Insert a wall anchor into mounting hole.
3. Insert a #6 drywall screw into the wall anchor, leaving approximately 3/8 in. (0.95 cm) of the screw head exposed for
hanging.
4. Attach device by sliding the key-hole slot onto the mounting screw. Ensure the device is properly secured and level.
Two-screw mount (B)
1. Mark and pre-drill two mounting holes into the wall surface. 1.75 in. (4.4 cm) distance between the two screw slots.
2. Insert wall anchors.
3. Remove device cover to attach the device to the wall surface by inserting # 6 drywall screws. Ensure the device is properly
secured and level.
A
B
Surface mount
3M™ Dual Lock
Fastener & Tape,
2" x 1" strips
1. Prepare the mounting area to ensure maximize adhesion. If there is moisture, dry the area first.
2. Press a black fastener strip and a clear adhesive strip together.
3. Remove the backing off of the clear adhesive strip(s) and affix to the back of the device. It's recommended to place the
strip(s) horizontally.
4. Remove the backing off of the black fastener strip and affix to mounting surface; creating a secure mount between the device
and mounting surface.
5. Verify the strips are securely fastened together and the device mount is secure.
Page 12
