Prime Design Limited Warranty. Seller’s sole and exclusive warranty (and Buyer’s sole and exclusive remedy and Seller’s entire liability for any breach thereof) with respect to the Goods is set forth in the Limited Warranty document available at primedesign.net/warranty-liability
(the “Prime Design Limited Warranty”).
▪
TM & © 2020 PRIME DESIGN. PROTECTED BY ONE OR MORE OF THE FOLLOWING PATENT NO.’s 6427889, 6764268, 6971563, 8991889, 9415726, 9506292, 9481313, 9776476, 9796340, 10470565, 10486608 AND OTHER PATENTS PENDING
6
FEA-0004 BO
X
ASSEMBL
Y INSTR
UCTIONS–LEFT SLIDE RO
TA
TION
4.6
Assemble the L Post
hardware. Do not
tighten until Step 4.8
Note:
The orientation of
the bolt hole faces away
from the Crossbar
Slide L Post Bracket Clamp into
bottom groove, then slide into
L Post Connector as shown
4.4
Bracket Clamp sits
in L Post Connector
Clamp as shown
4.5
Ensure the Auto Clamp Spring
is seated into the spring catch
4.3
L Post seats into the
Crossbar’s inside bottom
groove as seen from the
rear of the Front Crossbar
4.2
Place an L Post into the bottom
groove of the Front Crossbar
L POSTS
SEE QUICK START GUIDE FOR ADJUSTMENTS
NOTE:
The front Auto Clamp come preset from the factory
for packaging purposes only. To assemble the L Post to the
Crossbar, the Auto Clamps must be repositioned.
Beginning with the Front
Crossbar, loosen the bolt at the
bottom of the Auto Clamp, then
slide the Auto Clamp toward the inside
end of the Rotation Upper. Reposition
the Auto Clamp leaving a minimum
of 1/4” distance from the rubber
bumper to the edge of the Auto Clamp
Bracket as shown, then finger-tighten if
adjusting later, or torque to 80 in-lbs.
4.1
Summary of Contents for FEA-0004
Page 12: ...USAM FEA0004 US01 Rev A 0618 ...
