31 І 48
15. Troubleshooting
Problem
Possible Cause
Help
1. Saw blade gets
loose after turning off
the motor
Fastening nut tightened insufficiently
Tighten fastening nut, right-handed thread
2. Motor does not start
a) Fastening nut tightened insufficiently
b) Extension cable defect
c) Connections on the motor or switch
defect
a) Check the mains fuse.
b) See “Electrical Connection” in the operating
manual
c) Have it checked by an electrician
3. Motor has wrong
direction of rotation
a) Defective capacitor
b) Wrong connected
a) Check by qualified electrician
b) Exchange the polarity of the wall socket by
qualified electrician
4. Engine does not
provide power,the fuse
triggers
a) Cross-section of the extension line is not
sufficient
b) Overload by blunt saw blade
a) see Electrical connection
b) Change saw blade
5. Burns on the cutting
surface
with longitudinal
cuts with cross
cuts
a) Wrong saw blade
b) Longitudinal stop not parallel
c) Slide carriage not parallel
a) Insert a sharpened saw blade
b) Insert saw blade with 20 or 28 teeth for
longitudinal cuts
c) Exchange the longitudinal stop
Summary of Contents for 39013029933
