>
1
Introduction
Welcome to the Primare C31 Remote Control. This booklet explains how to use
the C31 to operate all the units in your Primare system.
W E L C O M E T O T H E C 3 1 R E M O T E C O N T R O L
The elegant C31 Remote Control allows you to operate all the units in your
Primare system with a set of simple and logical push button controls.
Ergonomic design
The C31 is designed to be extremely comfortable to hold, and its weight
makes it easy to balance it in the palm of a hand while operating the controls.
Its durable construction ensures that it will continue to operate perfectly for
many years to come.
Future proof
The C31 has been designed so that it can be upgraded to control future
products in the Primare range, not yet introduced, by the simple operation of
adding an upgrade chip.
C O D E B U T T O N
The
CODE
button allows you to select which Primare unit is controlled by the
C31 Remote Control.
Pressing the
CODE
button switches between the following three modes, as
shown by the
CODE
light:
CODE light
Controls
Off
CD players, P30/SP30 Processor, tuners, and integrated amplifiers.
On
DVD players, P30/SP30 Processor, tuners, and integrated amplifiers.
Flashing
CD players, PRE30
Preamplifier, and tuners.
Note:
After a short delay the
CODE
light dims to conserve the batteries. It will
light up again as soon as you operate any of the buttons.
D I S A B L I N G P R E 3 0 M O D E
If you do not have a PRE30 Preamplifier you can disable PRE30 mode as
follows:
•
Remove the C31 batteries, as described below.
•
Replace the batteries while holding down the
STBY
button.
To restore PRE30 mode:
•
Remove and then replace the batteries while holding down the
DIM
button.
