- 3 -
•
Use appropriate ppe during the job-e.g. heat resistant gloves & eye protection
against flying staples when cut.
•
Before inserting the staple, ensure that the two electrodes are cold.
•
Do not touch the staple or the electrode arms during the welding process.
•
Do not use near inflammable liquids or in fire risk areas.
•
Do not use in high humidity areas.
•
Switch-off after use.
•
This item is only for the repair of plastic.
•
Use Punto Plast only with original consumables.
•
Welding consumables GF16, GF18, GF26 GF28, GF38.
1.
Plug in the Punto Plast to the power supply (220-250VEU
)(110-115VUSA)
2.
Select the staple temperature based on plastic thickness and plastic type
■ plastic thickness up to 1,5 mm.
■■ plastic thickness up to 2 mm.
■■■ plastic thickness 2 mm. plus, (or very hard plastics of any thickness)
3.
Choose staple type and insert it
into the desired electrode slots (3
positions available)
4.
Weld the staple on to the inner
surface of the damage part
5.
Press the start button and apply
light pressure via the handle to
melt the staple correctly into the
plastic material
6.
Release the button when you have
melted the staple into the desired
position and wait few seconds for the
plastic to cool
7.
Repeat the process until the staples
are evenly distributed for maximum
stranth and then cut the staples
protrusion with the side cutters
supllied (wear safety glasses)
Instuctions for use
